SBM Vibrating Feeder

Illustration of How our Vibrating Feeder Installation & Debugging

The Vibrating Feeder can be offered after assembled and trial operation by our factory. The customers should check the machine after receiving it so as to make sure whether some problems appear during the transportation. When installation, debugging and trial operation, please pay attention:

1. Since the vibration of the feeder is heavy, it’s better to install the machine on concrete base. The height, depth and size of the base should be calculated according to the earth conditions. The weight of the base should be 1.5 times that of the machine. The installation size refers to the diagram. The height of the base and the discharging form can adopt steel structure or concrete platform according to the earth conditions to meet the need of the next working procedure. (according to customers’ requirement)

2. The discharging glide groove of the feeder belongs to addictive fixed device of the machine. It should be kept 90mm away from the feeder in vertical direction, and 30mm in horizontal direction.

3. When installing the motor and supporting frame, the central line and horizontal line of the wheel of the motor and the vibrator should form a degree of 45. The supporting plate and the supporting base of the motor should form a degree of 15-20. And the rotating direction of the vibrator should also be considered.

4. Clean the anti-dust oil in the vibrator and add lubrication oil. The type of the oil refers to the level of the oil is higher than the height of the mark.

5. After installation and debugging, try the trial operation. During the no-loading trial operation, pay attention:
(1) lasting for 2 hours without stop;
(2) all the firmware is fastened well;
(3) there is no abrasion, crump, rubbing and abnormal noise;
(4) the vibration is stable.

6. There are other requirement besides the above:
(1) when putting the raw materials into the feeder, do not impact the funnel, do not put materials in one side or over put raw materials to avoid damaging the machine, supporting spring and affecting the vibration of he machine;
(2) the max feeding size should be up to standard.